Material Safety Data Sheet
 


PRIMER T
AEROSOL
IDENTITY (as used on label and list)
SAF-T-LOK PRIMER T AEROSOL
Manufacturer’s name
SAF-T-LOK CHEMICAL CORPORATION
300 EISENHOWER LANE NORTH
LOMBARD, ILLINOIS, USA 60148		 Emergency Telephone Number
Chemtrec 1-800-424-9300
Telephone Number for Information
630-495-2001
Date Prepared
NOVEMBER 01, 2007
Section II—Hazardous Ingredients/Identity Information
Hazardous Components
(Specific Chemical Identity, Common Name(s))
OSHA PEL
ACGIH TLV

Other Limits Recommended
% (optional)
Acetone 67-64-1
750 750ppm    
Carbon Dioxide 124-38-9
  5000ppm    
   
       
All components of this product are listed on the Toxic Substance Control Act (TSCA) inventory of chemical substances maintained by the U.S. Environmental Protection Agency.
 

Section III—Physical/Chemical Characteristics
Boiling Point 133°F Specific Gravity (H20 = 1)     >1
Vapor Pressure (mm Hg)      @ 68°F 185 Melting Point N/A
Vapor Density (AIR = 1) 4.5 Evaporation Rate (Butyl Acetate = 1) ~.4
Solubility in Water Insoluble
Appearance and Odor Green Mist

 

Section IV—Fire and Explosion Hazard Data
Flash Point (Method Used)       0°F (SCC)
Flammable Limits  
LEL  N/A
UEL N/A
 

Extinguishing Media

 Carbon dioxide, dry chemical, foam.
Special Fire Fighting Procedures Water may be used to keep fire exposed containers cool until fire is out. Use air supplied mask and procedure for chemical fires.
Unusual Fire and Explosion Hazards Never use welding or cutting torch on container, because product can ignite. On burning product gives off hydrogen chloride and traces of phosgene and chlorine.
 
Section V—Reactivity Data
Stability Unstable   Conditions to Avoid
Acids, Strong Oxidizing Agents.
Stable X
Incompatibility (Materials to Avoid) Avoid contact with strong oxidizers, amines, strong Lewis or mineral acids, thiosulfates.
Hazardous Decomposition or Byproducts Considerable smoke and toxic fumes may be evolved as a result of uncontrolled exothermic reaction of large masses of material react with curing agents such as peroxides of amines. May form carbon dioxide & carbon monoxide.
Hazardous
Polymerization		 May Occur X Conditions to Avoid    
Storage in open containers, exposure to heat and/or open flame, exposure to incompatible substances.
Will not Occur  
 
Section VI—Health Hazard Data
Route(s) of Entry: Inhalation?
Yes		 Skin?
Yes

 Ingestion?
Yes
Health Hazards (Acute and Chronic)

Excessive inhalation of vapors can cause nasal and/or respiratory irritation. Contact with eyes may cause pain and irritation. Can cause severe irritation, redness, tearing, and blurred vision. Skin contact may cause irritation on repeated exposure. A component of this material has been shown to cause harm to fetus in Lab animals at high exposure levels.
Carcinogenicity:

        
NTP?
 No		 IARC Monographs?
 No		 OSHA Regulated
 No

 
Signs and Symptoms of Exposure

EYES: May cause pain or slight temporary irritation with slight temporary corneal injury. Vapors may irritate. SKIN: Prolonged exposure may cause irritation, drying and/or flaking. INHALATION: Excessive breathing of vapors may cause nasal and respiratory irritation, dizziness, weakness, fatigue, nausea, headache, and possibly unconsciousness.
Medical Conditions Generally aggravated
by Exposure

Pre-existing skin, eye & respiratory disorders may be aggravated by exposure.
Emergency and First Aid Procedures

INHALATION: Remove to fresh air, if breathing is difficult administer O2, if stopped give artificial respiration and consult physician. EYES: Flush with large amounts of water. SKIN: Thoroughly wash exposed area with soap and water. INGESTION: Do not induce vomiting, drink two glasses of water and consult physician.
 
Section VII—Precautions for Safe Handling and Use
Steps to be Taken in Case Material is
Released or Spilled

Quickly ventilate area especially low places where heavy vapors can collect and remove any open flames to prevent decomposition products from forming. Absorb spill with paper, cloth or vermiculite fillers.
Waste Disposal Method

Dispose in accordance with all Local, State and Federal regulations.
Precautions to be Taken
in Handling and Storing

Do not use in poorly ventilated or confined spaces. Keep containers tightly closed when not in use. Store in a cool (50°F - 80°F) dark place.
Other Precautions

Do not store or use near food.
 
Section VIII—Control Measures
Respiratory Protection (Specify Type)

Use air mask at high concentrations.
Ventilation:
Local Exhaust Necessary with large usage
Special N/A
Mechanical (General) Keep low areas free of vapors
Other N/A
Protective Gloves Butyl-Nitrile rubber gloves
Eye Protection Safety glasses with shields
Other Protective Clothing or Equipment

Rubber aprons, protective shoes to keep clean in large use.
Work/Hygienic Practices

Shower and wash well with plenty of water and soap.

The information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. Any use of the product which is not in conformance with this data sheet or which involves using the product in combination with any other product or any other process is the responsibility of the user.