Thread Sealing Pre-Assembled Threaded Joints
Thread Sealing / Threadlocking Application Method A-102
This method pertains to the application of SAF-T-LOK’S S90 on pre-assembled threaded joints. S90 Thread Sealant is a wicking type compound that will penetrate and seal pre-assembled threaded joints.
- Inspect the joints to be sealed and clean any contamination using primer if required.
- Apply S90 Thread Sealant compound to the pre-assembled joint. S90 is a wicking compound and will penetrate the joint.
- The assembled parts will be sealed within one hour. A full cure will occur within 24 hours (or 4 hours with Primer).
SAF-T-LOK and SAF-T-EZE are registered trademarks of SAF-T-LOK International Corporation.
All product names, logos, and brands are property of their respective owners. All product names, logos and brands used on this website are for identification purposes only.
All rights reserved.
No part of this site may be copied, reproduced or transmitted in any forms or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAF-T-LOK International Corporation.